---

devn-ne2000-403.so

Driver for NE-2000 403 eval board Ethernet adapters

Syntax:

io-net -d ne2000-403 [option[,option ...]] ...

Options:

---

Use commas (,) to separate the options (not spaces).

---

connector=type

Network cable connector type:

0

BNC

1

UTP

2

AUI

3

FIBER

The default is automatically detected on supported hardware.

did=devid

Device ID. The default is automatically detected on supported hardware.

duplex=dup

Half (0) or full (1) duplex mode. The default is automatically detected on supported hardware. If you specify duplex, specify speed as well; if duplex alone is specified, it is ignored and both speed and duplex are auto-negotiated.

ioport=port

I/O port of the interface. This must be 0xF4000000.

irq=req

IRQ of the interface. This must be 27.

mac=XXXXXXXXXXXX

MAC address of the controller. The default is automatically detected on supported hardware.

mtu=X

Maximum transmission unit. The default is automatically detected on supported hardware.

pci=0xXXXX

PCI index of the controller. The default is automatically detected on supported hardware.

speed=10|100

Media data rate (10Mbit or 100Mbit operation). The default is automatically detected on supported hardware. If you specify speed, specify duplex as well; if speed alone is specified, the specified speed will be correctly set, but duplex will default to half (0).

verbose
verbose=num

Be verbose. Specify num for more verbosity (num can be 1-4, the higher the number, the more detailed the output). The output goes to slogger, invoke sloginfo to view.

vid=0xXXXX

Vendor ID of the controller. The default is automatically detected on supported hardware.

width=X

I/O access width (8 or 16 bits). The default is automatically detected on supported hardware.

Description:

The devn-ne2000-403.so driver controls NE-2000 403 eval board Ethernet adapters.

Examples:

Start io-net using the NE-2000 driver and the full TCP/IP stack:

io-net -d ne2000-403 ioport=0xf4000000,irq=27 -p tcpip

Files:

/dev/io-net

The directory where, by default, drivers and protocol modules add entries. For more information, the documentation for io-net.

See also:

io-net

"Network drivers (devn-*)" and "Network protocol interfaces (npm-*)" in the Utilities Summary

---